Fast Pulse Detector

The circuit below is a schematic diagram of a fast pulse detector. At 100 ns  or wider pulse width, the detection should be error free. At 60 ns pulse width,  the detection error should be under 10%.

This circuit should be used to detect at least 100 ns wide pulse to ensure an error free performance. [Circuit's schematic diagram source: Linear Technology Application Notes]

Possibly Related Articles:

• Fast Peak Detector
  Fast peak detector requires special amplifier features. The output stage must have high slew rate to keep up with the intermediate stages of the amplifier. This condition causes either a...
• Open Loop Fast Peak Detector
  A fast peak detector similar but faster than previous peak detector, can be implemented using open loop configuration. Here is the schematic diagram of the circuit: In this  design, D1...
• Pulse Position Modulator
  Pulse position modulator can be easily built using 555 IC. Here is the schematic diagram of the circuit: Pulse position modulator modulate the on-period while keeping the fixed off-period. Pulse...
• Pulse Width Modulator Using 555 IC
  Pulse width modulator produce a PWM signal, a pulse with a constant frequency but with the duty cycle vary according to a modulating signal. Here is the schematic diagram of...
• Pulse Generator (Oscillator) With Adjustable On-Off Period Using CA3130 Op-Amp
  One of the interesting features of CA3130 op-amp  is its high input resistance, because using such high  input resistance, we can build an astable multivibrator with high R/C ratios. The...