This simpe circuit will convert the positive input voltage become negative voltage.
Schematic diagram:

Component list:
Part Total Qty. Description
R1 1 24K 1/4 Watt Resistor
R2 1 56K 1/4 Watt Resistor
C1 1 3300pF 25V Ceramic Capacitor
C2 1 47uF 25V Electrolytic Capacitor
C3 1 10uF 25V Electrolytic Capacitor
D1, D2 2 1N4148 Silicon Diode
U1 1 555 Timer
MISC 1 Wire, Board
Notes:
V+ can be anywhere from 4 to 16V. -V is one volt less than V+. So for -12V output, use +13V input. The maximum current output of the circuit is about 280mA, more than enough for a few op amps.
For better regulation, a 79LOxx series regulator can be used.
A zener diode may also be used to regulate the output voltage.
This may explore the standard operation of zener diodes and their use as voltage regulators. They are going to be made use of in ...
The circuit in figure two is Okay for quite small currents, when larger currents are needed we can add a "pass" transistor. The transistor ...
This is the magic lights circuit which use bi-colour LED as the output to provide the light. The circuit uses 14 bi-colour (red and green) ...
Here the simple file alarm circuit based timer ID NE555. The works is simple, the lamp give light to the LDR (Light Depending Resistor) as ...
Several technicians are {baffled} on the way to truly {study} a zener diode code. There are several kinds of code range indicated on {it is} ...
This entry was posted on Tuesday, February 14th, 2012 at 11:06 pm and is filed under electronic circuit. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.